Toro GrandStand 74534 - RH Motion Control Lever Installation

CONTROLS
4-736” & 40” Toro GrandStand Service Manual
4
RH Motion Control Lever Installation
10. Remove the bolt and jam nut from the motion control
assembly(Fig.205).
1. Installthefourplasticbearingstothemotioncontrol
assembly(Fig.207).
Fig. 205 DSCN-3634a
11. Removethefourplasticbearingsfromthemotion
controlassembly(Fig.206).
Fig. 206 DSCN-3637a
Fig. 207 DSCN-3637a
2. Loosely secure the adjustment cam to the RH
controllever(Fig.208).
Note: This nut will be tightened later in the process.
Fig. 208 DSCN-3629a