Toro GrandStand 74534 - Solenoid Installation

ELECTRICAL
8-34 36” & 40” Toro GrandStand Service Manual
8
Solenoid Installation
7. Remove the two thread forming screws securing the
solenoid the engine base plate (Fig. 829).
1. Secure the solenoid to the engine base using two
thread forming screws (Fig. 830).
Fig. 829 DSCN-2280a
Fig. 830 DSCN-2280a
2. Install the blue and green wires to the two small
studs on the solenoid using the wire’s bullet con-
nectors (Fig. 831).
Fig. 831 DSCN-2278a