ELECTRICAL
8-4136” & 40” Toro GrandStand Service Manual
8
3. Secure the position of the switch by tightening the
two mounting screws (Fig. 855).
Fig. 855 DSCN-2326a
4. Plug the wire harness into the switch (Fig. 856).
A. 1/8” (3mm)
Fig. 856 DSCN-2345a
1. Loosely install the two screws and threaded plate
that secure the switch to the brake assembly (Fig.
853).
Fig. 853 DSCN-2326a
2. With the brake engaged, position the switch so there
is an 1/8” (3mm) gap between the switch body and
the tab on the brake arm (Fig. 854).
Fig. 854 DSCN-2213a
Parking Brake Switch Installation
A
To Next Page
Loading...
