HYDRAULIC DRIVE SYSTEM
6-2 36” & 40” Toro GrandStand Service Manual
6
Pump Drive Belt Installation
6. Remove the drive belt from the engine pulley and
pump pulleys (Fig. 425).
1. Position the pump drive belt around the engine drive
pulley, the two hydraulic pump pulleys, and the idler
pulley (Fig. 426).
A. Hydraulic pumps D. Clutch retainer
B. Idler pulley E. Pump drive belt
C. Clutch pulley F. Pump drive pulley
Fig. 425 DSCN-2575a
Fig. 426 g.67G012686
2. Install the extension spring from the idler bracket to
the spring anchor (Fig. 427).
Fig. 427 DSCN-2660a
A
B
C
F
D
E
To Next Page
Loading...
