Toro GrandStand 74534 - Neutral (Proximity) Switch Installation

ELECTRICAL
8-3936” & 40” Toro GrandStand Service Manual
8
Neutral (Proximity) Switch Installation
1. Loosely install the two screws and nuts that secure
the switch to the switch mounting bracket (Fig. 846).
Fig. 846 DSCN-2305a
2. With the controls in the neutral position, position the
switch so the target printed on the body of the switch
is aligned with the bolt attached to the control lever
assembly (Fig. 847).
Fig. 847 DSCN-2308a
3. Secure the position of the switch by tightening the
two mounting screws (Fig. 848).
Fig. 848 DSCN-2305a
Note: Ensure the end of the bolt is within .070” ±
.020” (1.8 ± 0.5mm) of the switch body (Fig.
849).
Fig. 849 DSCN-2329a
A
A. .070” + .020” (1.8 + 0.5mm)