Toro GrandStand 74534 - Component Replacement; Ignition Switch; Ignition Switch Removal

ELECTRICAL
8-1136” & 40” Toro GrandStand Service Manual
8
Component Replacement
Ignition Switch
Ignition Switch Removal
1. Remove the wire harness and spade connector from
the back of the ignition switch (Fig. 743).
3. Remove the switch out through the front of the
control panel (Fig. 745).
Fig. 743 DSCN-2219a
2. Depress the two tabs on the sides of the switch (Fig.
744).
Fig. 744 DSCN-2223a
Fig. 745 DSCN-2224a