Toro GrandStand 74534 - Hydraulic Filter Mount Replacement; Hydraulic Filter Mount Removal

HYDRAULIC DRIVE SYSTEM
6-2736” & 40” Toro GrandStand Service Manual
6
Hydraulic Filter Mount Replacement
Hydraulic Filter Mount Removal
Note: Cleanliness is a key factor in a successful
repair of any hydraulic system. Thoroughly
clean all exposed surfaces prior to any type
of maintenance. Cleaning all parts by using
a solvent wash and air drying is usually
adequate. As with any precision equipment,
all parts must be kept free of foreign material
and chemicals. Protect all exposed sealing
areas and open cavities from damage and
foreign material.
Upon removal, all seals, O-rings, and gaskets
should be replaced. During installation, lightly
lubricate all seals, O-rings, and gaskets with
clean petroleum jelly prior to assembly.
2. Removethesuctionhosefromtheltermountinlet
tting(Fig.519).
1. Placeanoilpanunderthelterandremovethe
hydraulicoillter(Fig.518).
Fig. 518 DSCN-2910a
Fig. 519 DSCN-2913a
3. Removethesuctionhosefromtheltermountoutlet
tting(Fig.520).
Fig. 520 DSCN-2914a