Toro GrandStand 74534 - Hydraulic Filter Mount Installation

HYDRAULIC DRIVE SYSTEM
6-2936” & 40” Toro GrandStand Service Manual
6
Hydraulic Filter Mount Installation
3. Securethesuctionhosetotheoutlettting,then
securethepositionofthettingwiththejamnut(Fig.
527).
1. Securethehydraulicltermounttothelterbracket
using the two bolts and nuts (Fig. 524).
2. Installtheoutletttingintotheltermountoutletport
(Fig. 526).
Note: Do not tighten the jam nut at this time.
Fig. 524 DSCN-2921a
Note: Positiontheltermountsothe“FLOW”arrow
alignswiththearrowinthelterbracket(Fig.
525).
Fig. 525 DSCN-2928a
Fig. 526 DSCN-2919a
Fig. 527 DSCN-2936a