Toro GrandStand 74534 - Wheel Motor Installation

HYDRAULIC DRIVE SYSTEM
6-2136” & 40” Toro GrandStand Service Manual
6
Wheel Motor Installation
2. Secure the wheel motor to the frame using the four
boltsandnuts.Torquethefastenersto86±9ft-lbs.
(117±12Nm)(Fig.497).
1. Transfertheportidenticationmarkingstothenew
motor (Fig. 496).
3. Installthetwohydraulicttingsintothemotor.(Fig.
498).
Note: Do not tighten the jam nuts until the hoses
are connected.
Fig. 496 DSCN-2854a
Fig. 497 DSCN-2843a
Fig. 498 DSCN-2836a
4. Install the two hydraulic hoses, then secure the
positionofthehosettingsusingthejamnuts(Fig.
499).
Note: Ensure the hoses are connected to the cor-
rectportbyusingtheidenticationmarkings.
Fig. 499 DSCN-2829a