Toro GrandStand 74534 - Page 153

HYDRAULIC DRIVE SYSTEM
6-20 36” & 40” Toro GrandStand Service Manual
6
18. Toservicethewheelmotor,refertotheParker/Ross
WheelMotorServiceManual(HY13-1512-006-M1/
US).
14. Place a drain pan under the wheel motor and
disconnect both hydraulic hoses from the wheel
motor (Fig. 492).
17. Remove the four bolts and nuts securing the wheel
motor to the frame, then remove the wheel motor
(Fig. 495).
16. Loosenthejamnutsecuringthepositionofthet-
tings,thenremovethehydraulicttings(Fig.494).
Fig. 492 DSCN-2834a
15. Cap the hose ends to prevent debris from entering
the system (Fig. 493).
Note: If the wheel motor is going to be reused, cap
thehydraulicttingstopreventdebrisfrom
entering the system.
Fig. 493 DSCN-2840a
Fig. 494 DSCN-2836a
Fig. 495 DSCN-2843a