ELECTRICAL
8-12 36” & 40” Toro GrandStand Service Manual
8
Note: The switch must be orientated so it can be
read from the operator position (Fig. 747).
Fig. 747 DSCN-2227a
2. Install the spade connector with the two pink wires to
the “I” terminal of the switch (Fig. 748).
Fig. 748 DSCN-2232a
3. Install the wire harness to the switch (Fig. 749).
Fig. 749 DSCN-2234a
Ignition Switch Installation
1. Install the switch in through the control panel. En-
sure that the mounting clips have secured the switch
in the control panel (Fig. 746).
Fig. 746 DSCN-2224a
To Next Page
Loading...
