Toro GrandStand 74534 - Pump Drive Belt Idler Installation

HYDRAULIC DRIVE SYSTEM
6-536” & 40” Toro GrandStand Service Manual
6
Pump Drive Belt Idler Installation
1. Secure the idler pulley to the idler plate using a bolt,
washers and a nut (Fig. 436).
Note: The pulley hub needs to face the idler plate.
3. Place the large spacer, one friction composite
washerandbushingontothepivotbolt(Fig.438).
2. Place the pivot bolt with washer down through the
engine base (Fig. 437).
Fig. 437 DSCN-2789a
Fig. 438 DSCN-2793a
4. Place the idler assembly onto the pivot bolt (Fig.
439).
Fig. 439 DSCN-2797a
Fig. 436 DSCN-2784a
A. Bolt D. Idler Plate
B. Washer (2) E. Nut
C. Idler Pulley
A B
C
D
B
E