ELECTRICAL
8-14 36” & 40” Toro GrandStand Service Manual
8
Electric (PTO) Clutch Removal
Power Take Off (PTO) Switch Installation
1. Install the switch in through the control panel.
Ensure that the mounting clips have secured the
switch in the control panel (Fig. 753).
1. Turn the engine off and remove the key from the
ignition.
2. Turn the fuel shutoff valve to the “OFF” position (Fig.
755).
Fig. 753 DSCN-2258a
2. Install the wire harness to the back of the switch
(Fig. 754).
Fig. 754 DSCN-2248a
Fig. 755 DSCN-2516a
3. Remove the two sets of wingnuts and hold down
bolts securing the battery cover, then remove the
cover (Fig. 756).
Fig. 756 DSCN-2263a
Electric (PTO) Clutch Switch
To Next Page
Loading...
