Toro GrandStand 74534 - 4 Controls; LH Motion Control Lever Replacement; LH Motion Control Lever Removal

CONTROLS
4-136” & 40” Toro GrandStand Service Manual
4
LH Motion Control Lever
Replacement
LH Motion Control Lever Removal
1. Removetheshoulderboltandangenutsecuring
the end of the control cable to the LH motion control
lever(Fig.183).
Note: Only one bolt will typically back out due to
both threading into the same inner rod. A #4
easy-out can be used to secure the pivot rod.
The bolt on the opposite side can then be
removed (Fig. 185).
Fig. 183 DSCN-3570
2. Removethetwoboltssecuringthepivotshaftinside
the LH motion control lever. One bolt is located
on the outside of the control tower. The second is
locatedattheoppositeendofthecontrolhandle
(Fig.184).
Fig. 184 DSCN-3573
Fig. 185 DSCN-3584a
3. Remove the LH control lever assembly from the
control tower.
4. Removethepivotrodfromthemotioncontrolhandle
(Fig.186).
Fig. 186 DSCN-3591a