Toro GrandStand 74534 - Page 152

HYDRAULIC DRIVE SYSTEM
6-1936” & 40” Toro GrandStand Service Manual
6
10. Tightenthelugnutsevenly(approximately1/4to1/2
turn at a time) until the hub pops off the wheel motor
shaft(Fig.489).
9. Advance the forcing screw through the wheel hub
untilitrmlycontactsthewheelmotorshaft(Fig.
488).
11. Remove the hub puller from the hub.
12. Remove the woodruff key from the wheel motor
shaft keyway (Fig. 490).
Fig. 488 DSCN-2817a
Fig. 489 DSCN-2822a
Fig. 490 DSCN-2827a
13. Mark the hose and motor ports to ensure they are
installed correctly (Fig. 491).
Fig. 491 DSCN-2829a