Toro GrandStand 74534 - Page 151

HYDRAULIC DRIVE SYSTEM
6-18 36” & 40” Toro GrandStand Service Manual
6
3. Loosenthefourlugnuts(Fig.484). 7. Removethewheelmotornut(Fig.486).
Fig. 484 DSCN-2805a
4. Raise the rear of the machine.
5. Release the parking brake.
6. Remove the four lug nuts and remove the tire (Fig.
485).
Fig. 485 DSCN-2805
Fig. 486 DSCN-2806a
8. Installahubpuller(Torop/n:TOR6006)ontothe
wheellugbolts(Fig.487).
Note: The lug bolts need to be installed backwards
sotheatsideisagainstthepuller.
Fig. 487 DSCN-2813a