Toro GrandStand 74534 - Page 163

HYDRAULIC DRIVE SYSTEM
6-30 36” & 40” Toro GrandStand Service Manual
6
4. Installtheinletttingintotheltermountinletport
(Fig.528).
Note: Do not tighten the jam nut at this time.
6. Applyathincoatofhydraulicuidtotherubber
gasketonthereplacementlter(Fig.530).
Fig. 528 DSCN-2916a
5. Securethesuctionhosetotheinlettting,then
securethepositionofthettingwiththejamnut(Fig.
529).
Fig. 529 DSCN-2913a
Fig. 530 DSCN-2956a
7. Installthereplacementltertotheltermount(Fig.
531).
Fig. 531 DSCN-2910a