ELECTRICAL
8-3336” & 40” Toro GrandStand Service Manual
8
3. Remove the bolt, washer, and nut securing the red
positive cable to the battery terminal, then remove
the battery (Fig. 825).
5. Remove the nut and lock washer securing the
positive cable that goes to the starter (Fig. 827).
Fig. 825 DSCN-2270a
Fig. 827 DSCN-2276a
6. Remove the green and blue bullet connectors from
the two small studs on the solenoid (Fig. 828).
Fig. 828 DSCN-2278a
4. Move the terminal cover off the positive cable com-
ing from the battery, then remove the nut and lock
washer securing the positive battery cable and red
wire eyelet to the solenoid (Fig. 826).
Fig. 826 DSCN-2353a
To Next Page
Loading...
