CONTROLS
4-8 36” & 40” Toro GrandStand Service Manual
4
3. Loosely install the bolt and jam nut to the handle
assembly(Fig.209).
Note: The nut will be tightened in a later step.
5. Loosely secure the OPC switch to the motion control
assembly(Fig.211).
Note: The bolts will be tightened later in the
process.
Fig. 209 DSCN-3634a
4. Secure the RH control lever to the motion control
assemblywiththeshoulderboltandnut(Fig.210).
Fig. 210 DSCN-3626a
Fig. 211 DSCN-3644a
6. Installtheextensionspringtothemotioncontrol
assembly(Fig.212).
Fig. 212 DSCN-3646a
To Next Page
Loading...
