Toro GrandStand 74534 - Page 85

CONTROLS
4-18 36” & 40” Toro GrandStand Service Manual
4
7. Securetheclevispinusingthehairpincotter(Fig.
247).
A. Tire C. Gapbetween3/16”&
B. Brakebar  5/16”(5&8mm)
Fig. 247 DSCN-3837a
6. Securetheyokeatthelowerendofthebrakerodto
thebrakeassemblyusingtheclevispin(Fig.245).
Fig. 245 DSCN-3834a
Note: With the brake handle in the off position,
measure the distance between the brake bar
and tire. The distance needs to be between
3/16” and 5/16” (5 and 8mm). If adjustment is
needed, remove the clevis pin and rotate the
yoke accordingly (Fig. 246).
Fig. 246 g.60G012699
A
C
B