CHASSIS
3-536” & 40” Toro GrandStand Service Manual
3
3. Install grease seal into the wheel hub (Fig. 016). 6. Position the caster axle through the bearing and seal
assembly (Fig. 018).
Fig. 016 DSCN-0393a
4. Repeat steps 1, 2, and 3 on the other side of the
caster wheel.
5. Fill the center of the wheel hub with high-temp
grease (Fig. 017).
Fig. 017 DSCN-0406a
Fig. 018 DSCN-0398a
7. Install a spacer nut onto both ends of the caster axle
(Fig. 019).
Note: There should be approximately 3 internal
spacer nut threads visible on both sides,
indicating the axle is centered.
Fig. 019 DSCN-0379a
To Next Page
Loading...
