ELECTRICAL
8-3136” & 40” Toro GrandStand Service Manual
8
38. Turn the fuel shutoff valve to the “ON” position (Fig.
821).
Note: If a new electric PTO clutch was installed, the
clutch must be burnished. Refer to “Electric
PTO Clutch Burnishing Procedure” following.
Fig. 821 DSCN-2702a
36. Position the battery on the battery tray. Using the
bolt nut and washer, secure the positive battery
cable to the battery. Using the bolt nut and washer,
secure the negative battery cable to the battery (Fig.
819).
Fig. 819 DSCN-2698a
37. Install the battery cover with the two hold down bolts
and wing nuts (Fig. 820).
Fig. 820 DSCN-2700a
To Next Page
Loading...
