Toro GrandStand 74534 - Page 70

CONTROLS
4-336” & 40” Toro GrandStand Service Manual
4
3. Installthepivotrodintothecenterofthecontrol
handle(Fig.191).
5. Secure the control cable to the motion control lever
usingtheshoulderboltandangenut(Fig.193).
Fig. 191 DSCN-3591a
4. Secure the control handle assembly in the control
towerusingtwobolts(Fig.192).
A. .05”to.09”(1.27to2.29mm)
Fig. 192 DSCN-3573a
Fig. 193 DSCN-3570
6. Positiontheneutralswitchboltsothegapbetween
it and the switch is between .05” and .09” (1.27 and
2.29mm).Securethepositionusingthejamnut(Fig.
194).
Fig. 194 DSCN-3603a
A