Toro GrandStand 74534 - Page 72

CONTROLS
4-536” & 40” Toro GrandStand Service Manual
4
3. Removethetwoscrewssecuringthepivotshaft
insidetheLHmotioncontrollever(Fig.197&198).
Fig. 197 DSCN-3649a
Fig. 198 DSCN-3653a
Note: Only one bolt will typically back out due to
both threading into the same inner rod. A #4
easy-out can be used to secure the pivot rod.
The bolt on the opposite side can then be
removed (Fig. 199).
Fig. 199 DSCN-3647a
4. Remove the RH control lever assembly from the
control tower.
5. Removethepivotrodfromthemotioncontrolhandle
(Fig.200).
Fig. 200 DSCN-3616a