E6582062
6. [Advanced] How to use parameters 6-122
4
4
6
9
Memo
• The causes of the last eight trips can be displayed in [Monitor mode] even if the trip record
retention is set. For details, refer to [8. 1. 1].
• If the power is turned on again, the data at trip in [Monitor mode] will not be retained. Check the
data on the details monitor for the past trip history. For details, refer to [8. 1. 2].
• Even if the power is turned ON during retry, a trip record will be retained.
Reference
• How to operate the operation panel -> Refer to [3. 1. 1].
• How to switch display mode on the operation panel -> Refer to [3. 1. 2].
• Procedure to change parameter setting -> Refer to [4. 2. 3]
To Next Page
Loading...
