Treif PUMA-CE /E Series - Cutting Programs: Number and Type

11.5. Cutting programs: number and type
11.5.1 Number of memory locations:
The electronic control of TREIF PUMA-CE “electronic” has a total of 32
memory locations, which can be occupied by various cutting programs.
The program sites S1 to S20 are occupied with five sites each for the
four modes of operation. In addition, there are twelve free program sites
P1 to P12 to be used to change an existing cutting program and to assign
to a program function key (cf. chapter 11.4 )
Mode of operation
Mode of operation S1 - S5 S6 - S10 S11 - S15 S16 - S20
P1 - P12
11.5.2 Contents of the cutting program:
The content of a cutting program depends on the mode of operation.
Product name Product name Product name Product name
Cutting
thickness
Cutting
thickness
Cutting
thickness
Cutting
thickness
Length - - - - - - Length
Number of slices - - - - - - Number of slices
First cut * * - - - - - - First cut * *
Remaining piece - - - - - - Remaining piece
- - - - - - - - - Number of
empty cuts
- - - - - - - - - Number of slices /
stack
- - - - - - - - - Return travel
- - - - - - - - - 1/2 slice
*Toler. in
cutting thickn.
- - - - - - *Toler. in
cutting thickn.
Cutting zone - - - - - - - - -
Type of
optimisation
- - - - - -
Type of optimisation
type of knife type of knife type of knife type of knife
* = cf. chapter 11.9
Method of operation of the control
Page 34 02/2005 123842-GB