11.15. Operating mode single knife ’RS’
Cutting within several cutting ranges
(Definition "CUTTING RANGE", refer to section 11.9.)
This section describes the procedure applied, if a strand of cutting
material between a defined first cut [A] and a residual piece [B] is to be
cut in different cutting ranges (example = 3) and different slice thick-
nesses.
Selecting the cutting program
(cf. chapter 11.4:Program softkeys)
Set the main switch to »ON«.
After display of the program version, the control system automatically
performs a ’reference run’, in order to determine required length parame-
ters.
Cutting program "P1" appears a few seconds later.
s4 cutlets
CUTTING THICKNESS
22,0 mm (0,5-250)
*
Press program selector key "+" as often as required until the desired
cutting program is attained.
Method of operation of the control
Page 46 02/2005 123842-GB
To Next Page
Loading...