15.3. Greasing of the feed guide part
The friction bearing of the feed guide part has to be greased every 40 operating
hours. For this purpose use the grease gun supplied along with the machine.
IMPORTANT: Move product feed holder into its furthermost, right-hand end
position.
With a grease gun, pump several shots of grease into the grease
nipple, as shown in the drawing.
To be performed monthly:
Unscrew and remove the rear panel from the machine and wipe off
residues of grease from the feed guide assembly and sliding bar.
To refill the grease gun refer to your dealer for the type of grease
approved of by us. If you want to buy the lubricating grease yourself, use
one of the following greases:
Grease producer Kind of grease
MOBILUX
SHELL FB 2
DARINA FETT 2
ARALUB HL 2
MULTIFAK 20
ARAL
EURAL GREASE EP 2*
* USDA - H1approved
Maintenance
Page 72 02/2005 123842-GB
To Next Page
Loading...
