11.17. Conveyor control
(only for machines with conveyor)
Conveyor speed
...can be adjusted both prior to and during the cutting operation by means
of speed controller
2 . The adjustment is independent of the selected
cutting program.
Control
The control system of the machine automatically starts and stops the
conveyor belt. The operating mode is set via selector switch
1 :
–
Continuous operation
The conveyor belt runs at the set speed as soon as the main switch is
turned on. This setting is not dependent on the feed movement.
–
Cyclical operation
The conveyor belt runs at the set speed as soon as the cutting procedure
is started. During the manual start-up phase, the conveyor belt is stop-
ped. Immediately after the cutting procedure is ended, the belt stops.
–
Manual feed
The conveyor belt runs at the set speed as long as the selector switch is
held. It is possible to remove the cut slices without opening the removal
cover.
1 2
Method of operation of the control
02/2005 123842-GB Page 53
To Next Page
Loading...
