12.7. Return travel limitation of the product feed
holder
Purpose:
If a particular cutting programme is used always to cut short products
(e.g. escalope), the return travel of the product feed holder in the infeed
chamber can be limited. In this way, empty travels of the product feed
holder can be avoided.
Adjustment of the return travel limitation:
Use the keys ’forward movement of product feed holder’ and ’backward
movement of product feed holder’ (with the knife at a standstill) to move
the unit into the requested out-off position.
Briefly press the “Return travel limitation” key.
In the subsequent cutting cycles, the product feed holder will return to
the position set only. The following additional message will appear on the
display:
rueckwegbegrenzung
gesetzt
Cancel return journey limitation
Press the “Return travel limitation” key and keep it pressed until the
display indicates the cancellation of the return travel limitation.
NOTE The return travel limitation is not saved in the program. When the
machine is switched off, the return travel limitation set will be erased
automatically.
Cutting products
02/2005 123842-GB Page 57
To Next Page
Loading...