6. Transport and erection
6.1. Transport
We recommend to have the machine erected and connected by the
dealer only. It would be useful, if your own maintenance staff were
present during erection and connection.
Transport the machine as closely as possible to the site of erection,
before the packing is removed. Use a fork-lift truck or an elevating
truck to transport the machine.
Remove the packing, and examine the machine for possible transport
damage.
Advise the carrier immediately and in writing of any damage in transit.
Compare the delivery with the docket (delivery note) !
6.2. Erection
Use a fork-lift truck or a four-wheel lifting truck to move the machine
to its final erection site.
Attention: machines with conveyor
Dismantle the conveyor if you wish to move the machine with a fork
lift truck or elevating truck.
Dismounting the conveyor is described in chapter 7.1
Never drive the machine when the knife box door is open. Danger
of tilting !
If the machine wobbles:
Compensate potential unevenness of the floor by means of the
jackscrew (24 mm) in the right-hand side, rear foot of the under-
structure.
Counter the adjustment screw after setting.
Transport and erection
Page 18 02/2005 123842-GB
To Next Page
Loading...
