15. Maintenance
The function of the safety switches has to be verified after all
maintenance and repair work (chapter 8.2)
Carry out an operational check after every maintenance work.
Being the buyer/operator, have the check-up work confirmed. In this way
the adherence to the check-up work for safety and warranty reasons can
be verified easier.
For this purpose use the maintenance record in chapter 20.
For machines with conveyor:
Attention: Danger of tilting !
When the conveyor is fitted the machine is top heavy when the
knife box door is opened !
For this reason always dismount the conveyor when you wish
to open the knife box door !
15.1. Regular maintenance work
The following table lists all maintenance work to be carried out regularly.
Below the table the individual work will be described in greater detail.
work when chapter
sharpening of knife when blunt 15.2
lubrication of the guide part 40 operating hours 15.3
Adjustment of the counter-
blade
when new counterblade
is fitted
15.4
for machines with conveyor
retensioning of the conveyor
belt
when the conveyor belt runs
lopsidedly, resp. slips through
15.5
set spacing between
conveyor and counterblade
when a conveyor is fitted for
the first time
15.7
Maintenance
Page 70 02/2005 123842-GB
To Next Page
Loading...
