11.10. Storage of cutting programs
It is not necessary to store immediately each individual change of a
setting in MEMO/QUIT. Storage in MEMO/QUIT should be performed
only when all the settings of the program have been correctly adjusted.
Change of cutting program
If you change to another cutting program without having stored the
previous changes, the following display will appear:
save modified
parameters ?
P1: yes
P2: No
Save by pressing and keep pressed the Shift key and
P1 save cutting program
P2 do not save cutting program
Method of operation of the control
02/2005 123842-GB Page 39
To Next Page
Loading...
