– Number of empty cuts:
This parameter renders the number of knife revolutions, during which the
product is not fed forward. Empty cuts between 0 and 99 may be entered.
This parameter is selectable in LS mode of operation only.
– Slices/packet:
A number of slices from 0 to a maximum of 99 slices, which are cut
consecutively, can be set here.This parameter is selectable in LS mode
of operation only.
– Return travel:
This parameter determines the travel, by which the product is pulled back
from the cutting level during the empty cuts.
The first feed movement after the performance of empty cuts has to be
increased by the value set here. The adjustment range is between 0 and 10
mm.
This parameter is selectable in LS mode of operation only.
– 1/2 slice:
Adjustment of the slice thickness of the first two slices of a group or a
stack. If the thickness of the first two slices deviates to the thickness of
the following slices in a group, this adjustment value has to be modified.
The adjustment limits are between
+/- 10 mm.
This parameter is selectable in LS mode of operation only.
–
If the first slice is too thin and the second slice is too thick:
Enter the corrective value with the “
+
” sign.
–
If the first slice is too thick and the second slice is too thin:
Enter the corrective value with the “
-
” sign.
– Tolerance in cutting thickness:
By what the percentage the slice thickness entered may deviate from the
actual thickness of the cut slice is determined by selection of the slice
thickness tolerance.
The tolerance limits are between 0 and 20%.
This parameter is selectable in RS and LS modes of operation only
.
– Cutting zone:
The cutting zone is defined as being the division of a product rack into
pieces of different cutting thicknesses.
The maximum number of cutting zones is 10 pieces.
This parameter is selectable in RS mode of operation only.
– Type of optimisation:
This is the parameter to change the type of optimisation.
The Length and the Number of slices can be adjusted.
This parameter is selectable in RS and LS modes of operation only.
Method of operation of the control
02/2005 123842-GB Page 37
To Next Page
Loading...
