Trellix NS Series - Install the Interface Module During a Fresh Installation of the Sensor; Install the Interface Module on an up and Running Sensor

•
•
Install the interface module during a fresh installation of the Sensor.
Install the interface module on an up and running Sensor.
:
Install the interface module during a fresh installation of the Sensor
This section provides the steps to install the interface module for a fresh installation of Manager and Sensor.
Steps:
1. Remove the module from its protective packaging.
It is assumed that the Sensor is yet to be powered on, and trust between the Sensor and the Manager has not been
established.
2. Grip the sides of the module with your thumb and forenger and insert the module into the slot.
Install an interface module
3. Drive in the screws xed on the sides of the module to attach it to the Sensor.
4. Turn on the Sensor.
5. Establish trust between the Sensor and the Manager.
:
Install the interface module on an up and running Sensor
This section provides the steps to install the interface module on a Sensor which is up and running.
| NS7x50 Sensors4
Trellix Intrusion Prevention System NS-series Sensor Product Guide
183
Note