Trellix NS Series - License Requirement for NS7500 Sensor Failover; Managing Licenses for NS7500 Sensors

License requirement for NS7500 Sensor failover
Based on the throughput, the NS7500 Sensor requires an additional license for Sensor failover. To obtain a license, contact Trellix
Sales.
The table below shows the capacity licenses available for the NS7500 Sensor failover:
License SKUs Throughput Number of Sensors
FO75X03CAE-AT 3 Gbps 2 * 1 NS7500 Sensor
FO75X05CAE-AT 5 Gbps 2 * 1 NS7500 Sensor
FO75X075CAE-AT 7.5 Gbps 2 * 1 NS7500 Sensor
The table below shows the upgrade capacity licenses available for the NS7500 Sensor failover:
License SKUs Throughput Number of Sensors
NS75XF35CAE-DT 3 to 5 Gbps 2 * 1 NS7500 Sensor
NS75XF375CAE-DT 3 to 7.5 Gbps 2 * 1 NS7500 Sensor
NS75XF575CAE-DT 5 to 7.5 Gbps 2 * 1 NS7500 Sensor
You can upload the license from the Licenses page in the Manager. In the Manager, go to Manager → <Admin Domain Name> →
Setup → Licenses.
:
Managing licenses for NS7500 Sensors
The NS7500 Sensor requires a license to activate the baseline throughput of 3 Gbps. Additional license is required to increase the
throughput from 3 Gbps to 5 Gbps or 7.5 Gbps. The license is provided as a .zip or .jar le.
You must rst purchase a license to enable trac inspection in the NS7500 Sensor. To obtain a license, contact Trellix Sales.
Trellix Intrusion Prevention System NS-series Sensor Product Guide
| NS7500 Sensor3
154
Note