Trellix NS Series - Installation of the Interface Module; Install the Interface Module During a Fresh Installation of the Sensor

•
•
•
•
•
•
•
4-port 10/1 Gig SM 8.5 micron with internal fail-open interface module
4-port 10/1 Gig MM 50 micron with internal fail-open interface module
4-port 10/1 Gig MM 62.5 micron with internal fail-open interface module
6-port RJ-45 10/100/1000 Mbps with internal fail-open interface module
8-port SFP/SFP+ 1/10 Gigabit interface module
For more information, see the NS-series Interface Modules section in Trellix Intrusion Prevention System NS-series Reference Guide.
:
Installation of the Interface Module
This section provides instructions on how to install the interface module based on the following scenarios:
Install the interface module during a fresh installation of the Sensor.
Install the interface module on an up and running Sensor.
:
Install the interface module during a fresh installation of the Sensor
This section provides the steps to install the interface module for a fresh installation of Manager and Sensor.
Steps:
1. Remove the module from its protective packaging.
It is assumed that the Sensor is yet to be powered on, and trust between the Sensor and the Manager has not been
established.
2. Grip the sides of the module with your thumb and forenger and insert the module into the slot.
Install an interface module
| NS7x00 Sensors5
Trellix Intrusion Prevention System NS-series Sensor Product Guide
211
Note