:
Redundant power supply
The basic conī “guration of a Sensor includes two hot-swappable power supplies. Each of these modules has one handle for
insertion or extraction from the unit as well as a release latch. If you have purchased an additional power supply from Trellix,
refer to the following sections to remove and install the new power supply.
Power supply units
:
Install a new power supply
1.
Unpack the power supply from its shipping carton.
2.
Remove the faceplate panel covering the power supply slot.
Trellix Intrusion Prevention System NS-series Sensor Product Guide
| NS9x00 Sensors2
100
To Next Page