Trellix NS Series - About Fiber-Optic Ports; Contents of the Box; Unpack the Sensor

•
•
•
•
•
•
•
•
•
About ber-optic ports
The Sensor uses ber-optic connectors for its Monitoring ports. The connector type is an SFP/SFP+/QSFP+ ber optic connector
that is LC-duplex compatible.
Note the following:
Fiber-optic ports (for example, SFP/SFP+/QSFP+, FDDI, OC-3, OC-12, OC-48, ATM, GBIC, and 100BaseFX) are considered
Class 1 laser or Class 1 LED ports.
These products have been tested and found to comply with Class 1 limits of IEC 60825-1, IEC 60825-2, EN 60825-1, EN
60825-2, and 21CFR1040.
To avoid exposure to radiation, do not stare into the aperture of a ber-optic port. Invisible radiation could be
emitted from the aperture of the port when no ber cable is connected.
Only FDA registered, EN 60825-1 and IEC 60825-1 certied Class 1 SFP/SFP+/QSFP+ laser transceivers are acceptable for
use with the Sensor.
:
Contents of the box
The following accessories are shipped in the NS-series Sensor crate:
Sensor
Power supply (x2)
Power cords (Trellix provides a standard and international power cables)
Set of rack mounting rails
Printed quick start guide
40G Direct Attach cable
:
Unpack the Sensor
Steps:
1. Open the crate.
2. Remove the rst accessory box.
3. Verify you have received all parts.These parts are listed on the packing list and in Contents of the box section.
4. Remove the Sensor.
5. Place the Sensor box as close to the installation site as possible.
| NS9x00 Sensors2
Trellix Intrusion Prevention System NS-series Sensor Product Guide
95
Caution