Trellix NS Series - Setting up the Sensor; Setup Overview; How to Position the Sensor; Install the Slide Rails and Rack Mount the Sensor

6. Position the box with the text upright.
7. Open the top aps of the box.
8. Remove the accessory box within the Sensor box.
9. Verify you have received all parts.These parts are listed on the packing list and in Contents of the box section.
10. Remove the Slide Rail Kit.
11. Pull out the packing material surrounding the Sensor.
12. Remove the Sensor from the antistatic bag.
13. Save the box and packing materials for later use in case you need to move or ship the Sensor.
:
Setting up the Sensor
This chapter describes how to set up the Sensor for you to congure it.
:
Setup overview
Setting up a Sensor involves these steps:
1. Position the Sensor.
2. Install interface modules (SFP, SFP+ and QSFP+).
3. Attach power, network, and monitoring cables.
4. Turn on the Sensor.
5. Congure the Sensor after you have set up and turned it on.
:
How to position the Sensor
Place the Sensor in a physically secure location, close to the switches or routers it will be monitoring. Ideally, the Sensor should
be located within a standard communications rack. To mount the Sensor on a rack, you will attach two mounting rails to the
Sensor as described in the subsequent sections of this guide.
:
Install the slide rails and rack mount the Sensor
Trellix recommends rack-mounting your Sensor. For maintenance purposes, you must have access to the front and rear of the
Sensor.
Trellix Intrusion Prevention System NS-series Sensor Product Guide
| NS9x00 Sensors2
96