Trellix NS Series - Attaching Cables to the Sensor; Connect the Cable to the Console Port

Steps:
1. Disconnect the network ber-optic cable from the module.
2. Release the module from the slot by pulling the bail clasp out of its locked position.
3. Slide the module out of the slot.
4. Insert the module plug into the module optical bore for protection.
:
Attaching cables to the Sensor
Follow the steps outlined in this chapter to connect the cables to the various ports of your Sensor.
:
Connect the cable to the Console port
The Console port on the NS-series Sensor is used for setup and conguration of the Sensor.
Steps:
1. For console connections, plug the DB9 Console cable supplied by Trellix into the Console port on the Sensor.This port is
labeled Console in the Sensor front panel.
2. Connect the other end of the Console port cable directly to a COM port of the computer or terminal server you will use
to congure the Sensor, for example, a computer running correctly congured Windows HyperTerminal software.You must
connect directly to the console for initial conguration; you cannot congure the Sensor remotely. Terminal servers are
provided for console access. Required settings for HyperTerminal are listed below:
Name Setting
Baud rate 115200
Number of bits 8
Parity None
Stop bits 1
Flow control None
3. Turn on the Sensor.
Trellix Intrusion Prevention System NS-series Sensor Product Guide
| NS9500 Sensors1
40