Trellix NS Series - Turning the Sensor on and off; License Requirement for NS9500 Sensors

•
•
Active Fail-Open Kit Quick Start Guide
Passive Fail-Open Kit Quick Start Guide
:
Turning the Sensor on and o
Do not attempt to turn on the Sensor until you have installed the Sensor in a rack and made all the necessary network
connections.
Steps:
1. Connect the power cable to the Sensor power supply.
2. Connect the power cable to a power source.
If you are installing a redundant power supply, you should install it as described in Install a new power supply section. For
true redundant operation with the optional redundant power supply,Trellix recommends that you plug each supply into
a dierent power circuit.
The Sensor has no power switch. The Sensor turns on as soon as one of its power cables is connected to a power
source.Trellix recommends that you use the shutdownCLI command to halt the Sensor before turning it o. For more
information on CLI commands, see the CLI commands section in Trellix Intrusion Prevention System Product Guide for specic
Sensor software version you are running.
:
License requirement for NS9500 Sensors
The NS9500 Sensor requires a license to activate the baseline throughput. You must rst purchase a license to enable trac
inspection in the NS9500 Sensor. To obtain a license, contact Trellix Sales. Additional license is required to increase the
throughput of the Sensor.
The license is provided as a .zip or .jar le. The Manager supports both formats. The license procured contains the details of the
throughput for the Sensor.
The table below shows the capacity licenses available for the NS9500 Sensors:
Trellix Intrusion Prevention System NS-series Sensor Product Guide
| NS9500 Sensors1
46
Note
Note