•
•
•
•
•
Retype the password in Conrm Shared Secret.
The Sensor name and shared secret key that you enter in the Manager must be identical to the shared secret
that you will enter later during physical installation or initialization of the Sensor (using CLI interface) as stated
in the Congure Sensor information section. If not, the Sensor will not be able to register itself with the Manager.
Device Type — Species the type of device to be added. Select IPS Sensor.
Deployment Mode — Select Direct or Indirect.
Selecting Direct enables online Sensor update. Direct is the default mode.
Contact Information — (Optional) Type the contact information.
Location — (Optional) Type the location.
Comment — (Optional) Type the comment.
5. Click Save.
The added Sensor is displayed on the Sensors tab of Device Manager page.
:
Congure Sensor information
Congure the Sensor with the network information, a name, and the shared secret key that the Sensor uses to establish secure
communication with the Manager. Use the name and key values you set in Add the Sensor to the Manager section.
You must have physical access to the Sensor when you congure a Sensor for the rst time.
At any time during conguration, you can type a question mark (?) to get help on the Sensor CLI commands. Type commands for a
list of all commands.
Steps:
1. Log on to the Sensor using the terminal connected to the Console port.
2. At the prompt, log on using the default Sensor username (admin) and password (admin123).
Trellix Intrusion Prevention System NS-series Sensor Product Guide
| NS5x00 Sensors6
256
Note
Note
Tip
To Next Page