Trellix NS Series - Turning the Sensor on and off; Configure the Sensor and Manager for Deployment; Install the Manager Software

2. Connect the other end of the cable into port 1 of the standby NS3x00 Sensor. Only port 1 is required for failover to function
properly.
:
Turning the Sensor on and o
Do not attempt to turn on the Sensor until you have installed the Sensor in a rack and made all the necessary network
connections.
Steps:
1. Connect the power cable to the Sensor power inlet.
2. Connect the power cable to a power source.The Sensor has no power switch. The Sensor turns on as soon as one of
its power cables is connected to a power source.Trellix recommends that you use the shutdownCLI command to halt the
Sensor before turning it o. For more information on CLI commands, see the CLI commands section in Trellix Intrusion
Prevention System Product Guide.
:
Congure the Sensor and Manager for deployment
:
Install the Manager Software
Following steps briey explain the Manager installation:
You must have administrator privileges on the target Windows or Linux server to install the Manager software.
MariaDB is included with the Manager and is installed (embedded) automatically on your target Windows or Linux server
during this process.
Steps:
1. Prepare the system according to the requirements outlined in Trellix Intrusion Prevention System Installation Guide.
2. Close all open applications.
| NS3x00 Sensors8
Trellix Intrusion Prevention System NS-series Sensor Product Guide
299
Note
Note
Note