Trellix NS Series - Verify Successful Installation

7. Set the IP address and subnet mask of the Sensor. Type set sensor ip <A.B.C.D> <E.F.G.H> at the prompt.Example:set
sensor ip 192.168.2.12 255.255.255.0
Specify an IP address using four octets separated by periods: X.X.X.X, where X is a number between 0 and 255, followed
by a subnet mask in the same format.
8. If prompted, reboot the Sensor. Type reboot
The Sensor can take up to ve minutes to complete its reboot.
9. Ping the Manager from the Sensor to determine if your conguration settings to this point have successfully established the
Sensor on the network. At the prompt, type the following command:ping <manager IP address>If the ping is successful,
continue with the following steps. If not, type show to verify your conguration settings and check that the information is
correct.
10. Set the shared secret key value for the Sensor. At the prompt, type the following command:set sensor
sharedsecretkeyThe Sensor then prompts you to enter and, subsequently, conrm the shared secret key value.
This value is used to establish a trust relationship between the Sensor and the Manager. The secret key value can be
between 8 and 25 characters of any ASCII text. The shared key value is case-sensitive. Make sure the value matches the
shared secret key value you provided in the Manager interface while adding the Sensor.
11. Type show to verify the conguration information. Check that all information is correct.
12. Type exit to exit the session.
:
Verify successful installation
Steps:
1.
Type status in the Sensor CLI.The status report appears.
Trellix Intrusion Prevention System NS-series Sensor Product Guide
| NS5x00 Sensors6
258
Note
Note
Note