Trellix NS Series - Unpack the Sensor; Setting up the Sensor; Setup Overview; How to Position the Sensor

:
Unpack the Sensor
Steps:
1. Open the crate.
2. Remove the rst accessory box.
3. Verify you have received all parts.These parts are listed on the packing list and in Contents of the box section.
4. Remove the Sensor.
5. Place the Sensor box as close to the installation site as possible.
6. Position the box with the text upright.
7. Open the top aps of the box.
8. Remove the accessory box within the Sensor box.
9. Verify you have received all parts.These parts are listed on the packing list and in Contents of the box section.
10. Remove the Slide Rail Kit.
11. Pull out the packing material surrounding the Sensor.
12. Remove the Sensor from the antistatic bag.
13. Save the box and packing materials for later use in case you need to move or ship the Sensor.
:
Setting up the Sensor
This chapter describes how to set up the Sensor for you to congure it.
:
Setup overview
Setting up a Sensor involves these steps:
1. Position the Sensor.
2. Install the supported interface modules as per your requirement.
3. Attach power, network, and monitoring cables.
4. Turn on the Sensor.
5. Congure the Sensor after you have set up and turned it on.
:
How to position the Sensor
| NS9500 Sensors1
Trellix Intrusion Prevention System NS-series Sensor Product Guide
23