Trellix NS Series - Sensor Leds

•
•
•
•
•
•
•
•
•
Ports
NS7100/NS7200/NS7300
4-port 10/1 GigE MM 50 micron with internal fail-
open
4-port 10/1 GigE MM 62.5 micron with internal fail-
open
6-port RJ-45 1 GigE with internal fail-open
8-port (SFP+/SFP) 10/1 GigE
10 Gigabit Ethernet Modular up to 18
Dedicated Response ports (RJ-45) 1 (1G/100M/10M)
Dedicated Management ports (RJ-45) 1 (1G/100M/10M)
Dedicated Auxiliary port (DB9) 1
USB ports 2
Console port — Use to set up and congure the Sensor using the CLI.
RJ-11 port — Controls the SFP+ 1/10 Gigabit Ethernet port pair in passive fail-open mode
SFP/SFP+ 1/10 Gigabit Ethernet ports — Enables to monitor two SPAN ports, two segments in-line, or a combination
RJ-45 10/100/1000 Mbps Ethernet Monitoring ports — Enables to monitor eight SPAN ports, four segments in-line, or a
combination
DB9 Auxiliary port — Use to dial in remotely to set up and congure the Sensor.
External USB ports — Use these in troubleshooting situations for system recovery purposes. You need to restart the
Sensor through the USB storage device.
RJ-45 10/100/1000 Management port— Use for communication with the Manager server. You can assign an IP address
to this port during installation.
RJ-45 10/100/1000 Response port — When you're operating in SPAN or tap mode, enables you to inject response packets
back through a switch or router.
Power Supply — Power supply is included with an NS7x00 Sensor. The supply uses a standard IEC port (IEC320-C13).
Trellix provides a standard, 2m NEMA 5-15P (US) power cable (3 wire). International customers must procure a country-
appropriate power cable.
The NS-series Sensor does not have internal taps; you must use it with a third-party external tap to run it in tapped mode.
:
Sensor LEDs
| NS7x00 Sensors5
Trellix Intrusion Prevention System NS-series Sensor Product Guide
201