Trellix NS Series - About Fiber-Optic Ports; Contents of the Box

•
•
•
•
•
•
•
•
•
This equipment is intended to be grounded. Ensure that the host is connected to earth ground during normal use.
Do not operate the system unless all cards, faceplates, front covers, and rear covers are in place. Blank faceplates
and cover panels prevent exposure to hazardous voltages and currents inside the chassis. The chassis contains
electromagnetic interference (EMI) that might disrupt other equipment and direct the ow of cooling air.
To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network voltage (TNV)
circuits. LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Some LAN and WAN ports both use RJ-45
connectors. Exercise caution when connecting cables.
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant to Part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference when the
equipment is operated in a commercial environment. This equipment generates, uses, and can radiate radio frequency
energy, and if not installed and used in accordance with the instruction manual, might cause harmful interference to
radio communications. Operation of this equipment in a residential area is likely to cause harmful interference, in which
case the users will be required to correct the interference at their own expense.
Refer to the Appendix for information on regulatory, compliance, and other safety requirements.
:
About ber-optic ports
The Sensor uses ber-optic connectors for its monitoring ports. The connector type is an SFP/SFP+ ber-optic connector that is
LC-duplex compatible.
Note the following:
Fiber-optic ports (for example, SFP/SFP+, FDDI, OC-3, OC-12, OC-48, ATM, GBIC, and 100BaseFX) are considered Class 1
laser or Class 1 LED ports.
These products have been tested and found to comply with Class 1 limits of IEC 60825-1, IEC 60825-2, EN 60825-1, EN
60825-2, and 21CFR1040.
To avoid exposure to radiation, do not stare into the aperture of a ber-optic port. Invisible radiation could be
emitted from the aperture of the port when no ber cable is connected.
Only FDA registered, EN 60825-1 and IEC 60825-1 certied Class 1 SFP/SFP+/ laser transceivers are acceptable for use
with the Sensor.
:
Contents of the box
The following accessories are shipped in the NS-series Sensor crate:
Sensor
| NS5x00 Sensors6
Trellix Intrusion Prevention System NS-series Sensor Product Guide
239
Caution