Trellix NS Series - Configure Sensor Information

Capacity Sensor name
40 Gbps <Stackname-1>
<Stackname-2>
60 Gbps <Stackname-1>
<Stackname-2>
100 Gbps <Stackname-1>
<Stackname-2>
<Stackname-3>
<Stackname-4>
8. Using the Sensor CLI, congure the Sensors with the same name and node ID as the names displayed in the Device
Manager page.
9. In the Manager, go to Manager → <Admin Domain> → Setup → Licenses and upload the license for the stack. You must
manually push the conguration after the license is assigned to the stack.For more information on licenses, see Managing
licenses for NS9500 Sensors.
:
Congure Sensor information
Congure the Sensor with the network information, a name, and the shared secret key that the Sensor uses to establish secure
communication with the Manager.
You must have physical access to the Sensor when you congure a Sensor for the rst time.
At any time during conguration, you can type a question mark (?) to get help on the Sensor CLI commands. Type commands for a
list of all commands.
1. Log in to the Sensor using the terminal connected to the Console port.
2. At the prompt, log in using the default Sensor username (admin) and password (admin123).
Trellix Intrusion Prevention System NS-series Sensor Product Guide
| NS9500 Sensors1
66
Tip