Trellix NS Series - Page 67

•
•
3. (Optional, but recommended) Change the Sensor password. At the prompt, type passwd. The Sensor prompts you to enter
the new password and asks you for the old password.
A password must contain between 8 to 25 characters, is case-sensitive, and can consist of any alphanumeric character
or symbol.
4. Set the Sensor mode to stack or standalone based on your requirement using the set sensor mode <stack | standalone>
command.You will be prompted to reboot the Sensor to change the mode. Press Y to conrm.
5. Set the name of the Sensor.
You can enter the setup command at the prompt which will automatically prompt you to provide the information shown
in the subsequent steps of this section. Or, you can use the set command instead. If you use the set command, you
must manually enter the complete command syntax as shown in the subsequent steps of this section.
For a standalone Sensor, type: set sensor name <word> at the prompt.Example: set sensor name HR_sensor1
For Sensors in the stack, type set stack name-node idat the prompt.Example: set sensor name NS9500_Stack-1
The Sensor name is a case-sensitive character string up to 25 characters. The string can include hyphens, underscores,
and periods, and must begin with a letter.
You reset the Sensor to change the mode using the resetconfig command.
| NS9500 Sensors1
Trellix Intrusion Prevention System NS-series Sensor Product Guide
67
Note
Tip
Note